Flame Genasi Mage Ember BitetheBullet Resin Miniature D&D Warhammer pinup NSFW

Description

Ember - Flame Genasi Exotic - BitetheBullet Resin Miniature D&D pathfinder warhammer rpg NSFW pinup.
Bite the Bullet models come in
35mm
scale. I can do 23mm, 32mm, and 75mm. Just select offer and add note which scale you would like.
Ember comes in
SFW
or
NSFW
topless with depicted base.
Please specify which variant you prefer in Note to Seller.
Since she was very little, Ember always had problems relating to others, her temperamental nature, her eccentric personality and her lack of discipline when using her powers made it very difficult to make friends (without burning them).
As she grew older, her powers and her ability to control them (when she wanted to control them) increased dramatically (more her powers than the ability to control them) and Ember became a notorious criminal with a very bad reputation in her city.
And the fact that she had Genasi blood and a very advanced dominion of fire spells only served to make her considered herself superior to almost everyone else of the city.
Fires in the wealthiest neighborhoods happened on a daily basis and this is how she earned gher nickname, the Firestarter.
When the "Wanted" signs began to appear all over the streets of the city with her face (always smiling) on them it only served to increase her already excessive ego.
But Ember took the increase of security in the streets not as a risk but as a conquest and she took that opportunity to change of scenery and grow her reputation on a larger scale.
Since then, both her bounty and her powers have only increased and Ember is on the most wanted criminals list for the entire country.
As the saying goes ... if you play with fire, you'll end up getting burned, and another thing that can also happen ... is that what end up getting burn ... are your clothes.
Disclaimer:
This model is printed on a resin 3D printer. Resin Color may vary. The model will be roughly cleaned of supports but may contain small marks from support removal or sanding. This is a normal aspect of 3D printing and these markings are minimized to the greatest extent on my end and will disappear once primer is applied to the model in most cases. For the remaining cases, some minor filing may be required. I also use a special resin blend to increase the strength of the model but care must still be taken as resin is more prone to breaks than typical PVC models.
This model will be printed at the standard 35mm. Other sizes can be accommodated just please PM me before you do any transactions.
I am officially licensed by BitetheBullet to sell their models. For additional information on their product line please see:
https://www.patreon.com/BiteTheBullet/
https://www.myminifactory.com/users/BiteTheBullet